OSPF动态路由协议配置 实验报告

按图配置OSPF路由协议,要求:
⑴ 仅配主干区域area 0;
⑵ 设router0 、router2的s0/0接口为DCE;
⑶ 使用packetrace工具配置,并将配置过程和命令记录下来。

第1个回答  2011-01-05
Router>ena
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#ro
Router(config)#router o
Router(config)#router ospf 1
OSPF process 1 cannot start. There must be at least one "up" IP interface
Router(config-router)#p
Router(config-router)#passive-interface in
Router(config-router)#passive-interface s
Router(config-router)#passive-interface serial 0/0/0
Router(config-router)#p
Router(config-router)#passive-interface S
Router(config-router)#passive-interface Serial 0/0/1
Router(config-router)#EXIT
Router(config)#IN
Router(config)#INterface S
Router(config)#INterface Serial 0/0/0
Router(config-if)#CL本回答被提问者和网友采纳
第2个回答  2011-01-14
Router>ena
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#ro
Router(config)#router o
Router(config)#router ospf 1
OSPF process 1 cannot start. There must be at least one "up" IP interface
Router(config-router)#p
Router(config-router)#passive-interface in
Router(config-router)#passive-interface s
Router(config-router)#passive-interface serial 0/0/0
Router(config-router)#p
Router(config-router)#passive-interface S
Router(config-router)#passive-interface Serial 0/0/1
Router(config-router)#EXIT
Router(config)#IN
Router(config)#INterface S
Router(config)#INterface Serial 0/0/0
Router(config-if)#CL
第3个回答  2011-01-16
DCE是硬件决定的,不能配置,你用母头的时候就是DCE了。注意DCE需要配置时钟。

楼上的passive意思是单播更新,配错了。
第4个回答  2011-01-05
楷书
相似回答